MIDI Jack Installation

Installation: Step By Step

  1. Remove the drum machine right side panel by removing the two screws.
  2. Measure and mark a rectangle for a cutout. You can make the cutout using a router, drill and/or a jigsaw.
    Photo of panel cutout
    The lower edge of the cutout should be 1 inch (25 mm) from the bottom edge of the panel
    Photo of panel cutout
    and 1 3/16 inch (30 mm) tall.
    Photo of panel cutout
    The right side of the cutout should be 6 3/4 inches (171 mm) from the back edge of the panel
    Photo of panel cutout
    and 2 3/8 inches (60 mm) wide.
    Photo of panel cutout
  3. Use the MIDI jack plate as a marking guide to mark the position of the mounting holes. Be sure to align the plate evenly with the bottom of the panel.
    Photo of panel cutout

    Photo of panel cutout

    Photo of panel cutout
  4. Use a 7/64 drill (2.8mm) to predrill the holes for the mounting screws.
    Photo of panel cutout
  5. Attach the jack plate using the screws provided.
    Photo of panel cutout
  6. Reattach the panel to your drum machine.

For further assistance, contact Electrongate by email.